Joined
·
739 Posts
GROUP BUY: $999 shipped for weapon7 splitter AND rocker blades!!!!!!
Hi Guys,
We're running a GROUP BUY for 10 guys on our carbon splitter and rocker blades. These are American made and priced so competitively that even our carbon fiber rivals most fiberglass kits! They're made from the same molds and come gel coated ready to prep and paint. They use OEM mounting locations as well!
Composite splitters and rocker blades are $999 shipped!
Carbon Fiber with clear coat are $1499 shipped!
Splitter - It has a nice lip across the front that tapers up and angles downward between the two fins on the lower front bumper lip so there's no awkward flat step up to try and bridge the gap. This space between the fins also provides some driveway relief! I know a couple of you guys were worried about the winglets on the side. They're in line with the tires and they're very short, so they blend in very well, but really draw some nice attention as well! It uses all OEM mounting bolt holes and if present, you can reattach your air deflectors under them if you wish.
Rocker blades - These run wheel to wheel and don't flare out until past the door line. We did this not only for style but to also keep the road rash off the bulging rear fenders. Again, these use all OEM bolt hole for mounting.
Enjoy the pics!
Notice the splitter and hood profile



side profile of splitter, rockers, and spoiler



Check out the splitter and hood profile!






The END


Hi Guys,
We're running a GROUP BUY for 10 guys on our carbon splitter and rocker blades. These are American made and priced so competitively that even our carbon fiber rivals most fiberglass kits! They're made from the same molds and come gel coated ready to prep and paint. They use OEM mounting locations as well!
Composite splitters and rocker blades are $999 shipped!
Carbon Fiber with clear coat are $1499 shipped!
Splitter - It has a nice lip across the front that tapers up and angles downward between the two fins on the lower front bumper lip so there's no awkward flat step up to try and bridge the gap. This space between the fins also provides some driveway relief! I know a couple of you guys were worried about the winglets on the side. They're in line with the tires and they're very short, so they blend in very well, but really draw some nice attention as well! It uses all OEM mounting bolt holes and if present, you can reattach your air deflectors under them if you wish.
Rocker blades - These run wheel to wheel and don't flare out until past the door line. We did this not only for style but to also keep the road rash off the bulging rear fenders. Again, these use all OEM bolt hole for mounting.
Enjoy the pics!
Notice the splitter and hood profile



side profile of splitter, rockers, and spoiler



Check out the splitter and hood profile!






The END

