Stingray Corvette Forum banner
1 - 7 of 7 Posts

· Registered
Joined
·
533 Posts
Ok I have included 2 pictures of a friends new C7 Conv. trunk area. The Cover for the top sticks out and looks like its not a quality fit.

He would like to know if this is a issue with everyone or just his.

I sugested Velcro or some tape of double side tape to hold it in place.

Trunk Vehicle Car Vehicle door Automotive exterior
Vehicle door Automotive exterior Arm Hand Bumper
Suggestions
 

· Registered
Joined
·
3,674 Posts
I have that "feature" on my convertible - easily correctable but I have been doing too much driving.:)
 

· Registered
Joined
·
1,197 Posts
Though I don't have a picture, I don't think that mine sticks out like that at all.
 

· Registered
Joined
·
1,108 Posts
Mine sticks out just about the same. cutnout aka Charlie
 

· Registered
Joined
·
533 Posts
Discussion Starter · #6 ·
Mine sticks out the same way. Not quite the same fit as my C6. Maybe velcro would be the answer. It's not a problem, just doesn't look as good as it could.

Michael
I agree.. It could look a lot better if it would have a pin like on each side installed.
I told him Velcro would be much faster and with out drilling.
 

· Registered
Joined
·
1,385 Posts
So I viewed your issue and mine is the same, but while looking at the same issue of the OP, voila!!! I have a weather stripping issue!! I wish I could go a week with this car without some freaking issue coming up, either major or minor.

Automotive exterior Vehicle door Vehicle Floor Car
Vehicle door Red Automotive exterior Windshield Automotive window part
 
1 - 7 of 7 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top