Stingray Corvette Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello, I am picking up blindly a rest-modification project. I'm curious about best adhesive to use for side Stingray Emblem and rear smallish CORVETTE in individual letters (chrome) unlike Stingray where it is all one piece.

Side & rear Emblem.JPG
 

·
Registered
Joined
·
5,453 Posts
These parts should already have adhesive attached.....open the packages....if not thin 3m vhb tape off amazon will work.
 

·
Registered
Joined
·
1,147 Posts
The original versions of these emblems have posts that go throught the body, then have "speed nuts" installed to hold the emblems in place - no adhesive of any kind. I've not seen any reproduction pieces without the posts either, though its possible some have come out recently. The post versions will need holes drilled into the body panels, if they are not already there. If needed, you can make a template by pushing the posts into some foam core board, then position the board on the body, mark the holes with a Sharpie. Double check your positioning before drilling, and make sure nothing is behind the panel the drill might hit.
 
1 - 6 of 6 Posts
Top