Stingray Corvette Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
5,453 Posts
Discussion Starter #1
American Car craft put up a good vid for getting off the shoulder vents for painting, cleaning, etc - FAR too much work for me, but here it is:

 

·
Registered
Joined
·
59 Posts
I just installed the Z06 vents on my 2014 Z51. This video was very helpful. Took about 30 minutes per side. Thanks very much for posting. Just a couple of notes. The 3 nuts that hold the vents on are actually 8 mm nuts and the screws are a T10 not a T15. Other than that...great video.
 

·
Registered
Joined
·
74 Posts
I personally think the stingray vents look better than the ones that come on. The z06 ... (#ilovethez06) Just my opinion ...
 

·
Registered
Joined
·
21 Posts
Does anyone know for sure if the American Car Craft replacement metal grills will fit the Z06 vents as well as the Stingray grills?
 
1 - 5 of 5 Posts
Top