[glen e]

I read on the sites that CQUK and other coatings benefit from using this product over other washes...

1. does it do a good job stripping everything off except the CQUK and the reload? I have some aquawax on the car that works great over the CQ....

2. do you then reload again?

got some ordered - will report back

Interesting comments here:

http://www.autopiaforums.com/forums/washing-drying-claying/45860-carpro-reset-opin.html#post517605

 

[Liner Boy]

Glen, I have been using this on my C7 now for several months. This was on the list of products that Kody Keuter recommended after applying the CQuartz . I can tell you it is a great product. And makes washing the car very quick. I use a Master Blaster to blow the water out of all the vents and most of the water off the car. Then dry it with one of Corey's fancy German made micro fiber towels. Done and ready to roll in about 30 minutes.


Sent from my iPad using Corvette Stingray Forum

 

[glen e]

Thanks !

 

[glen e]

well got it today and for the first time since I've owned the C7, I used a hose on the car! But had to try this soap that is recommended for use if you have a coating and esp Cquartz. I was not disappointed. Observations:

1. it is slick - 1 oz in 3 gallons of water and it slides on the car
2. smells great
3. leaves the surface very slick and seems to rejuvenate the Cquartz/Reload as advertised.

I can see this being a monthly wash with rinseless/aquawax stuff in between:

Just dried, no other products applied as a detailer, etc:

 

[Liner Boy]

Glad you liked it!


Sent from my iPhone using Corvette Stingray Forum

 

[Liner Boy]

It really doesn't take much water. I figure using the 2 bucket method I use less than 10 gallons to wash and rinse


Sent from my iPhone using Corvette Stingray Forum