Stingray Corvette Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
22 Posts
Discussion Starter #1
Noticed a few loose screws under rear hatch cover on rail. They are not fully screwed in and project about 1/4 to 3/8 inch above surface. Have not screwed in yet because concerned plant may have put in wrong length screws. Strange to have not fully screwed in since drivers usually have preset torque.
 

·
Registered
Joined
·
124 Posts
Pics?
 

·
Registered
Joined
·
124 Posts
Chip beat me to it.
 

·
Registered
Joined
·
22 Posts
Discussion Starter #6
Service rep says probable low air pressure on driver at plant, They retorqued all the fasteners in channel under rear lid.
 
1 - 7 of 7 Posts
Top