Memory seats - starting over

5567 Views 5 Replies 5 Participants Last post by Yellow n red, Feb 3, 2014

Georgio51

Discussion Starter · Nov 21, 2013

Does anyone know if seat and exit memory can be erased/deleted? I can't seem to override a current setting and replace with new positions.

Save

1 - 2 of 6 Posts

Georgio51

Discussion Starter · #4 · Nov 22, 2013

mjw930 said:
If it's like the memory recall on my last Chevy it should be as simple as setting everything where you want it, press and HOLD both the Set and 1 buttons until you hear a confirmation beep (it may take a few seconds if it is over writing an old setting). I used to do it all the time while the car was running as I found that perfect spot for the seat and wheel.

You may need to go into the personalization menu and turn off the auto recall. It may only allow one memory position per keyfob when the auto recall option is set. I also would do it when the car is running or on. I seem to recall it was finicky when the ignition wasn't on.

Sent from my iPad using Corvette Stingray Forum

Sure...I'm getting the 'beeps' and it worked just fine on the initial setting. Revisions seem to confuse it, however. I will check personalizaton and one-position per is a logical supposition and could result in the 'confused' action. I'm not using any of the manual functions on the fob. I'm simply depressing the door lock on exit and proximity unlock on entry. Can't imagine you would need to use active fob functions for basic functions in this day and age. That said, there's a pretty wordy and confusing section in the manual that talks about the remote. I gave up on that pretty quickly.

Save

1 - 2 of 6 Posts

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.

Top Contributors this Month