Stingray Corvette Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
19 Posts
Discussion Starter #1 (Edited)
I have a GM Template kit for a Z51 spoiler but will work on any spoiler that fits in factory holes(This is a GM kit I ordered for a Chevy dealership). It is complete with instructions, factory attachment nuts, everything you would get with kit. Made of plastic(use over and over) and tapes to rear fascia. Drop price to $45.00 for it and I'll pay shipping. I did use the template to mark my locations on Z51 spoiler I installed on my Stingray but the holes were not drilled thru the template as all I did was to use a scratch awl and put small needle size hole in center of bolt locations so Template is not damaged in any way. Also, if you need the instructions on how to remove rear fascia i will send them with the kit. I am a Chevrolet Technician and will print the document for you. This installation is not hard to do with or without a lift and very few tools needed. PM me if interested. I am in Virginia. Thanks, CB
 
1 - 2 of 2 Posts
Top