Stingray Corvette Forum banner

Xpel vs 3M

7487 Views 14 Replies 9 Participants Last post by  mjw930
I have read a lot on here about Xpel and was planning on having my new car covered with 3M. I am doing research on it but wanted people who used these products feedback. All opinions welcome. "What is better, which have you used, and why."


Sent from my iPhone using Corvette Stingray Forum
1 - 3 of 15 Posts
I ran an experiment. I emailed Expel and asked for a sample of their films, Ultimate and Extreme. I purchased a small piece of 3M Clear Bra and 3M VenturShield from Amazon. I also obtained a sample of Avery nano-Fusion. Now I had 5 films to evaluate. I purchased a piece of clear Lexan at Home Depot. I applied the films side by side. Then I placed the Lexan sheet over printed material and observed clarity. I looked for orange peel and adhesive distortion. Then I roughed the film surface using a kitchen scouring sponge. I placed the films in the sun to see if they self healed. I marked the film with a black marker to see if it could be cleaned. I tried applying polish.

Two films came out on top, Avery nano-Fusion and Expel Ultimate. The 3M films were last.

However, as someone else has said on this forum, the 3 most important things in selecting a film are: (1) the installer, (2) the installer, and (3) the installer.
I'm impressed! More of an answer than I ever thought I would get. I was leaning towards Xpel but on the fence due to the cost difference. I think you have just pushed me over.


Sent from my iPhone using Corvette Stingray Forum
Yes I agree with elegant. Total thought went into the tests, and it was easy to follow along with what was done and the results. I appreciate very much what you did and sharing this with us. This is going to be tremendous help to everyone here on the forum.


Sent from my iPhone using Corvette Stingray Forum
1 - 3 of 15 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top