Stingray Corvette Forum banner
1 - 5 of 5 Posts

· Senior Member
Joined
·
18,694 Posts
Discussion Starter · #1 · (Edited)
Still with camouflage, but we get to see the "Stage 2" rear deck spoiler, etc. for the first time. Thanks to "Corvette_Nut"/ACS Composites for the pictures.

First time we also see the "Stage 1" Z with the identical-to-the-Z-51 rear deck spoiler (bottom pic below).









 

· Senior Member
Joined
·
18,694 Posts
Discussion Starter · #4 ·
In this pic we see the standard Z06 (Stage 1) -- on the right. Note its front splitter does not have any vertical winglets; it is smaller to balance front and rear downforce with the Stage 1's standard Z-51 spoiler. Also noteable, in the picture of the rear fascia of the Stage 1, Z06 in this thread's first post, is that the lower fascia air-ducting vents appear to be narrower. Might they be the same as those in the StingRay?


As the Z06 is going through ten more months of calibrations, it is possible we will see "fine tuning adjustments" to some the components shown in this thread's pictures.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top